403 Forbidden
ERR_WEB_NGX_403
Checkout using your account
This form is protected by reCAPTCHA - the Google Privacy Policy and Terms of Service apply.
Checkout as a new customer
Creating an account has many benefits:
Estimated lead times
4-6 Days
Estimated lead times
4-6 Days
Order information: We can supply or match almost any RAL, BS or NCS colour, please call 0800 304 7616 if the colour you require is not available on the colour drop down.
Years / Environment
|
|||||||
---|---|---|---|---|---|---|---|
Interior | Semi-interior | Rural | Urban | Industrial / Coastal | Marine | Swimming pools & Chemical plants | |
Corrosivity Category | C1 | - | C2 | C3 | C4 | C5 | - |
Austenitic Stainless Steel A4 Grade (316) | 40 | 40 | 40 | 40 | 30 | 25 | 0 |
Substrate
Steel
|
0.5 mm |
Steel | |
0.5 mm | 1.05 kN |
NR,II,K (Tensile - Pull-out) | 0.5mm Steel: 0.6 kN |
Substrate
Steel
|
S15 washer |
Steel | 0.5 mm |
0.5 mm | 3.6 kN |
Installation tool | Variable speed electric screw gun |
Installation drive | Fixfast Matchfast MF1165 |
Installation speed | 1500 RPM |
Correct installation | Fasteners should be driven within three degrees of perpendicular to the surface of the fastened material. Use a depth-setting nosepiece to avoid over-driving, and do not over-tighten. Variants with bonded washers should not have the rubber compressed to less than two-thirds of its uncompressed height. Care should be taken when engaging and disengaging from the fastener head to avoid damage to the protective coating. |
Handling | Fasteners may have sharp edges, and the use of power tools can be dangerous. Use personal protective equipment. Store fasteners in dry conditions. Inspect each fastener before use and do not use damaged fasteners. |
Order information: We can supply or match almost any RAL, BS or NCS colour, please call 0800 304 7616 if the colour you require is not available on the colour drop down.
Years / Environment
|
|||||||
---|---|---|---|---|---|---|---|
Interior | Semi-interior | Rural | Urban | Industrial / Coastal | Marine | Swimming pools & Chemical plants | |
Corrosivity Category | C1 | - | C2 | C3 | C4 | C5 | - |
Austenitic Stainless Steel A4 Grade (316) | 40 | 40 | 40 | 40 | 30 | 25 | 0 |
Substrate
Steel
|
0.5 mm |
Steel | |
0.5 mm | 1.05 kN |
NR,II,K (Tensile - Pull-out) | 0.5mm Steel: 0.6 kN |
Substrate
Steel
|
S15 washer |
Steel | 0.5 mm |
0.5 mm | 3.6 kN |
Installation tool | Variable speed electric screw gun |
Installation drive | Fixfast Matchfast MF1165 |
Installation speed | 1500 RPM |
Correct installation | Fasteners should be driven within three degrees of perpendicular to the surface of the fastened material. Use a depth-setting nosepiece to avoid over-driving, and do not over-tighten. Variants with bonded washers should not have the rubber compressed to less than two-thirds of its uncompressed height. Care should be taken when engaging and disengaging from the fastener head to avoid damage to the protective coating. |
Handling | Fasteners may have sharp edges, and the use of power tools can be dangerous. Use personal protective equipment. Store fasteners in dry conditions. Inspect each fastener before use and do not use damaged fasteners. |